RN22 i odblokowanie ECU - wszelkie informacje.
Autor Wiadomość
NoExpert Offline
Amerykanin
***

So. Cal
2014 R1 RN23

Liczba postów: 229
Dołączył: Mar 2015
Reputacja: 7
RE: RN22 i odblokowanie ECU - wszelkie informacje.
It's actually pin 27 on the 09-14 34 pin coupler.

Step 1: Expose your ECU
Step 2: Connect the blue lead of the FT ECU QuickShifter Harness to a chassis
ground or sensor ground.
Step 3: Unlock the coupler pins by pushing in on the white plastic locking tab. You should hear the connector click as the lock disengages. – (Fig. 1)
Step 4: Insert the green wire and pin from the FT ECU QuickShifter Harness into the rear of the ECU coupler (where the white plastic plug was)
 09-14 R1 - 34 Pin Coupler - Insert pin into pin location 27
Step 5: Lock the coupler pins by pressing the locking pins you should hear the connector click as the lock engages. If the connector does not lock check for loose or incorrectly seated contacts. – (Fig. 2)
Step 6: Connect to your shift sensor wire, reconnect to the ECU, reinstall your seat or fairing.

Which strain gauge setup did you get? May need to cross reference their instructions to make sure you wire it up correctly.

If you run the bike side harness, you need a different QS harness since pin 27 is used by the bike side harness. If you use a bench system, nothing to worry about.
(Ten post był ostatnio modyfikowany: 2016-08-28, 08:58 PM przez NoExpert.)
2016-08-28, 08:54 PM
Szukaj Odpowiedz cytując ten post


Wiadomości w tym wątku
RE: RN22 i odblokowanie ECU - wszelkie informacje. - PonuryKlecha78 - 2013-01-17, 01:13 PM
RE: RN22 i odblokowanie ECU - wszelkie informacje. - NoExpert - 2016-08-28, 08:54 PM
RE: R1 rn22 - Tomierłan - Siupa - 2016-03-06, 12:49 PM
RE: R1 rn22 - Tomierłan - [Ziutek] - 2016-03-06, 01:15 PM

Dodatkowe informacje


Skocz do:

-->